6/13/2023 0 Comments Xbee sample managerYou will need to configure your XBee modules so they can communicate. Note: there are kits available for the XBee antenna and Explorer USB modules, such as this one from Trossen Robotics. You could use any dev boards that have a serial port. I chose Arduinos because I happened to have two on hand. Male headers (0.1”) to be soldered onto the Explorer modules.Two small breadboards (or one larger breadboard).Two (2) XBee Explorer USB Modules, available here, and USB cables.Two (2) Series 1 XBee Antenna Modules, available here.*Bonus fact: ZigBee is named after the “ waggle dance” that bees use to point other bees to food sources. Its range is 10 to 30 meters. ZigBee is often used in home automation products, though it is not the only option. Get to Know XBeeįirst, let’s talk about ZigBee*, a low-power wireless mesh network standard operating in the 2.4 GHz range. XBee is not the same as ZigBee-instead, XBee is a brand of radio communication modules (made by Digi) that can support a number of protocols, including ZigBee, 802.15.4, WiFi, etc. We’ll have a basic input (a button) on one side, which will remotely trigger an output (an LED) on the other side. This models the basic functionality of the overall Callaloo system: proximity sensors on the door (input) are transmitted to a receiving module that changes an output (indicator lights, server information) based on the data it receives. The goal is to get two XBee modules to communicate. This blog post will cover the steps (and some background knowledge) needed for a basic XBee setup. And looking forward, installing wireless mesh-network infrastructure will be a good experience: developing our “intranet of places” using current internet of things technology. Bathroom availability should not be a significant issue in the new space, but the monitor has become a useful and familiar part of our office. This system, built by a former Atom, works as an occupancy sensor for each of our bathrooms, illuminating a green or red light on the wall to signify which bathrooms are available. In addition to migrating furniture, computers, and people down the street, we will also be moving an updated version of our “Callaloo” bathroom monitor system to our new home. For my part, I found an opportunity to try out a technology that I have not worked with before, the wireless networking system XBee. We’re excited about designing the new space. Now open XCTU and connect you radio(s), the first thing we want to do is change the baud rate to 115200 and write the changes.You may have heard the news: Atomic Object is moving to a new building later this summer. Now we can prepare a script to write the bin file via the xmodem protocol, dump the following in file, modify to your specific port and make it executable: This is the program we need to upload to the processor to allow us to talk directly to the radio. So as there is a separate processor in between the radio and the serial connection, we want to upload a program that allows us to passthrough commands direct to the radio, I’m assuming this is what XCTU-NG does when it communicates with programmable radios.Īfter the XBee SDK and codewarrior are installed, open up code warrior and select the following:įile > New > XBee sample application project > (select your XBee model) > XBee - Serial Bypass > Next & Finishįind you workspace folder and in there there should be a folder called serial_bypass, within this there should be a file called serial_ either in the Debug or Release folder. XCTU-NG - The new/current version of XCTU XMODEM transfer application - I used ‘sx’ under linux USB XBee adapters (i didn’t have the recommended XBIB board) Codewarrior (option to install as part of SDK setup)
0 Comments
Leave a Reply. |